HYDROCYCLONE FILTER

HYDROCYCLONE IRRIGATION FILTERS

The hydrocyclone enables sand and other heavier particles to be separated from water. As a result of the centrifugal force, the solid particles move towards the wall of the cone in a downward spiral thanks to the force of gravity, until they fall into the lower collecting tank where they are stored.

The clean water exits the hydrocyclone through the pipe at the top and the solid particles accumulated in the bottom tank are removed regularly.

Available up to PN16.

 

Technical Data Sheet

R+D+i Department

With more than 25 years of experience in product development in the sector.

Personalised advice

Our technical sales team will solve your doubts or needs.

Need help?

Technical information:

*In the mobile version, swipe to the right to view the entire table.

HYDROCYCLONE FILTER
CONNECTION
MAXIMUM FLOW
CODE
(“)
(m³/h)
1½" FEMALE THREAD
13
458419
2" MALE THREAD
21
457257
3" SHORT FLANGE
35
458420
3" FLANGE
50
460876
4" FLANGE
60
458423

HYDROCYCLONE FILTER INSTALLATION

It is installed vertically, with the overflow chamber below the hydrocyclone, paying special attention to the correct direction of flow: the horizontal inlet and the vertical upper outlet.

HYDROCYCLONE FILTER OPERATION

•Normal working conditions are achieved when the pressure drop in the hydrocyclone is no less than 0.2 bar (3 PSI).

•The maximum operating pressure must not exceed 8 bar.

• Recommended pressure drop: 0.2 bar- 0.5 bar (Higher pressure drop can lead to increased erosion and smaller pressure drop reduces the separation efficiency)